What does PPU mean on my harley davidson?

It was likely PPU 82883. It stands for the electronic Speedometers Pulse Per Unit.

How do you pull the codes on a Harley Davidson?

To enter the diagnostic system and retrieve a trouble code, hold down the trip reset button while turning the ignition from off to on. This will allow you to cycle through the categories, and see which one indicates a code.

How to check codes on a 2003 road king?

6 – To get the DTC within an area of diagnostics, push and hold the odometer reset button in for 5 seconds and release. If there are any DTC’s the code will be displayed or the word “none” will appear if there are no DTC’s. Push the odometer reset button again to view additional codes if they exist.

What is a DTC on a Harley?

DTC – Diagnostic Trouble Codes. ECM – Electronic Control Module. ECT – Engine Coolant Temperature. ECU – Electronic Control Unit. EFI – Electronic Fuel Injection.

What is PPU code?

PPUs are not an error code. That’s the speedometer signals Pulse Per Units used calibrating speed displayed on the speedo, cancelling turn signals and bit else. The number will vary by speedometer part number.

How do you reset the pin on a Harley 2020?

1. Turn the IGN key to IGNITION and immediately hold both turn signal switches until 5 dashes appear in the odometer window.
2. Enter the first digit of your PIN by pressing the LEFT turn signal switch (X) times.
3. Press the RIGHT turn signal switch 1 time to move to the next digit.

What is BCM on Harley?

Body Control Module
Custom Dynamics® Dynamic Load Isolator (DLI) for Harley-Davidson® uses the latest technology to isolate the motorcycle’s Body Control Module (BCM) allowing for the use of almost any aftermarket lighting product or electrical accessory.

How do you test a Harley ignition switch?

Test for voltage at the red wire , it should read battery volts . If there’s battery volts at the red wire then the switch isn’t working . If no volts then go back to the ignition relay and check for volts , work your way back from the switch .

What does low RNG mean on Harley?

“LO RNG” to indicate that the motorcycle will shortly run out of fuel. When the low fuel warning lamp turns on, the fuel level is low. Refuel as soon as possible. The range display is only updated when the vehicle is moving. The automatic fuel range display is enabled after the ignition is turned OFF IGN.

What is the factory pin for Harley?

Harley puts a standard factory preset PIN code and it is usually 31313.