How long should a Potterton Suprima boiler last?

about 20 years
1 Answer from a MyBuilder Heating Engineer Potterton suprima should last about 20 years, the rust you are seeing is just surface rust, probably from a very,very small leak above it.

How do I reset Potterton?

1. Reset. bar.
2. Off position. The boiler will not operate.
3. Central heating. and hot water. Both heating and. hot water will operate.
4. Hot water. Hot water will operate.
5. Reset. Hold for approximately. 5 seconds and release.

Is Potterton Suprima a condensing boiler?

The Potterton Suprima 50L has a SAP seasonal efficiency rating of 78.1%. The Suprima 50L is a Non-Condensing Conventional boiler with a maximum power output of 14.7kw that uses Gas as its fuel source.

What does orange light on Potterton boiler mean?

At first I was think PCB fault as its a common problem, but on the side panel the LED status light is a continues orange, which I means “no call for heat”.

Where is the reset button on Potterton profile boiler?

Profile 30e, 40e, 50e, 60e, 80e, and 100e

1. Make sure your heating is turned ON at the programmer, and in particular the room thermostat is turned up high.
2. find and press the ‘reset’ button underneath.
3. The pilot light.

Where is the reset button on a Potterton profile?

What KW is a Potterton Suprima 80?

23.4kw
The Suprima 80 is a Non-Condensing Conventional boiler with a maximum power output of 23.4kw that uses Gas as its fuel source.

Why is my Potterton boiler flashing red?

If the Status LED is showing continuous or flashing Red the boiler will need resetting. will attempt to re-light. Warning: If the LED is flashing Red rapidly the control is in remote diagnostic mode. The boiler will not operate in this mode and will need to be reset again.

Why is the reset button flashing on my Potterton Suprima?

The boiler was a Potterton Suprima and the gentleman was regularly having to press the reset button as the red light was often flashing and the boiler was not running. The fault had been happening for the past six months but was gradually worsening.

What are the LEDs on Potterton Suprima boiler?

The original PCB had two LEDs (red and green) which could be used to diagnose faults. The new PCB has a single LED which is able to produce three colours (Green, orange and red) and will flash various colours at various rates depending upon the boilers status. The boiler was set to be on when I arrived, and had been on as the radiators were warm.

When does Potterton Suprima 60 Go Red Hot?

If it gets too hot then the overheat stat kicks in. We need to know if it is red hot? The overheat stat should trip at about 87 degrees (too hot to put your hands on the pipes) if it is tripping too low and causing a nuisance then replace that first.

When to replace Potterton Suprima 60 lockout circuit?

The overheat stat should trip at about 87 degrees (too hot to put your hands on the pipes) if it is tripping too low and causing a nuisance then replace that first. If it is really that hot then we have to look at the other 3 parts of the temperature control circuit above.