How do I reset my orbit sprinkler controller?

How do I reset my orbit sprinkler controller?

Reset to Factory Default – Orbit Irrigation B-hyve Help. To reset your timer back to factory settings: Turn the timer to the OFF position by rotating the dial. Open the front panel and press the reset button for 10 seconds.

Why is my orbit Sprinkler not working?

If you are still not getting power, the timer may be defective. Turn the flow-control stem located at the connection from the Orbit to the main water line in a counterclockwise direction if one or more of the sprinklers is not responding to programming. Recheck the programming of the Orbit to ensure it is correct.

How do I manually test my orbit sprinkler system?

Turn the dial to the “Auto” position and move the slide switch for the desired valve up to the “Manual On” position to test valves on Orbit’s “Individual Station Slide” timers. To test all the valves in sequence, simply press the “Manual” key and press “Enter.”

Where is reset button on orbit?

Push the “Reset” button (located in the bottom-right corner) to clear all previously programmed data if you’re programming the Orbit sprinkler timer for the first time.

How do I turn on my orbit sprinkler system after winter?

Steps to turn on sprinkler system after wintering

  1. Find system’s main shut-off valve.
  2. Find the vacuum breaker.
  3. Close the vacuum breaker test valves.
  4. Open the vacuum breaker’s shut-off valves.
  5. Reinstall main valve bleeder cap (as needed).
  6. Slowly open the main valve.
  7. Test the system.
  8. Recheck the vacuum breaker and valves.

How do I know if my sprinkler controller is bad?

Sprinkler System Troubleshooting — 5 Signs Of A Faulty System

  1. Controller Isn’t Working Properly.
  2. Low or High Water Pressure.
  3. Sprinkler is Stuck or Won’t Come Up.
  4. Puddles on Lawn or Around Sprinkler.
  5. Uneven Spray Patterns.
  6. When to Call a Professional.

How long do sprinkler controllers last?

One of the components that you may need to replace regularly are the wires, often due to improper installation and corrosion. Valves will give you 10 to 15 years of service, while controllers 5 to 10 years.