How do you adjust the draw length on a bowtech general?

Draw length can be adjusted by changing the draw modules. The modules will allow for adjustments in 1/2″ increments. When changing the draw length of the General, it is necessary to adjust the draw stop as well. Adjusting the stop post will allow for additional draw length adjustments in 1/16″ increments.

Which bows can be adjusted for draw length?

Adjustable cams allow the archer to adjust his or her draw length with the use of an hexagonal wrench without, in most cases, pressing the compound bow. Adjustable compound bow cams allow archers to adjust anywhere from 3 inches up to 13 inches depending on the compound bow.

How do you adjust the draw length on a bowtech captain?

By simply rotating the mod- ule clockwise or counter-clockwise, your draw length can be adjusted in 1/2” increments.

How do you adjust the draw length on a bowtech assassin?

To lengthen the draw length, rotate the module so that the module index points to a lower number. For example, if an Assassin was shipped from the factory with the module index pointing at the #2 at 29 inches of draw length, it would point at the #1 for a 30 inch draw length.

How do you determine your draw length?

To measure your draw length, stand with your back to a wall stretching your arms out against the wall. Measure the distance from the end of your middle finger to the end of your other middle finger, basically the length of both arms, hands and chest. This measurement, minus 15 then divided by 2, is your draw length.

How do you adjust the draw length on a bowtech guardian?

The Guardian and Commander Center Pivot Bows do not require the use of a bow press to replace string and cables or to adjust the bows draw weight. To adjust draw weight, equally back- off both limb bolts counter-clockwise (1 full turn = approximately 2–5 lbs).

How do you adjust the draw length on a bowtech TomKat?

On the TomKat, you can change the drawlength by changing out the small black modules on each of the cams. If down the road you want to change the draw length, you’d have to get a different pair of modules from your pro-shop or buy them (ebay, AT, or BowTech).